What we do on the 915 gearbox
Rebuild to factory specification
complete stripping, measurement and reconditioning — hypoid drive set up with original tooling, test-bench run at the end.8:35 final drive (i = 4.375)
the short RS/RSR ratio as a new part — teeth ground on drive and coast side to 0.0025 mm, serial-numbered, with measurement report and etched setting dimension.Limited-slip differential
available for 18 and 43 teeth and for the variant with mechanical oil-pump drive.Stub axle, 43 teeth, Ø 109.90 mm
1:1 interchangeable in original appearance — long discontinued by the manufacturer.Rotation-direction change
for mid-engine conversions, with fresh setting of the hypoid drive.
Typical problems this solves
- Crunching second gear — the 915 classic: worn synchromesh and dog teeth
- Howling final drive after an improperly set ring-and-pinion swap
- Worn stub axle with no original replacement available
- Standard ratio too long for hill climbs or circuits
Why inquire here
We know hardly any gearbox better. From a single engagement ring to the complete homologation-ready racing gearbox, everything for the 915 comes from one workshop — measured, documented, test-bench run.